auna multimedia TBA-928 Bedienungsanleitung Seite 16

EN
16
Installation
1. Unpack all parts and remove protective material.
2. Do not connect the unit to the mains before checking the mains voltage
and before all other connections have been made.
3. Do not cover any vents and make sure that there is a space of several
centimetres around the unit for ventilation.
STEREO PHONOGRAPH OPERATION
Please Note - Before use
• Remove the stylus protector.
• Make sure that the tone arm is unlocked and free to move from the tone
arm rest prior to operating. Lock the tone arm again when not in use.
1. Turn on the system until the " power led" light up.
2. Set the speed selector to the proper position depending on the record to
be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The
platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record ano return it to the
rest.
NOTE: Some types of records may have an auto-stop area outside the
preset limit, so the turntable may stop before the last track finishes. In
this case, set the AUTO-STOP switch to the "OFF" position. This allows the
record to play to the end, but please note that it will not stop automatically.
You must manually raise the tone arm and place it back in the rest and then
turn off the power to stop the turntable from spinning.