Initial Commission; Commission After A Firmware Update Or A Long Period Of Non-Use - elektroautomatik PS 5080-05 A Betriebsanleitung

2.3.8

Initial commission

For the first start-up after purchasing and installing the device, the following procedures have to be executed:
• Confirm that the connection cables for DC to be used are of a satisfactory cross section
• Check that the default settings for set values, safety and monitoring functions and communication are suitable
for your application and change them where necessary, as described in the manual
• In case of remote control via PC, read the additional documentation for interfaces and software
2.3.9

Commission after a firmware update or a long period of non-use

In case of a firmware update, return of the equipment following repair or a location or configuration change, similar
measures should be taken to those of initial start up. Refer to „2.3.8. Initial commission".
Only after successful checking of the device as listed may it be operated as usual.
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
PS 5000 A Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
Page 25