Alarm Signals; Technical Data; Approved Operating Conditions; General Technical Data - elektroautomatik PS 5080-05 A Betriebsanleitung

1.7.5

Alarm signals

The equipment the possibility to signal alarm conditions, however, not danger situations. The signals are optical,
on the display as text). All alarms will cause the device to permanently or temporarily switch off the DC output.
The meaning of the signals is as follows:
Signal OT • Overheating of the device
• DC output will be switched off temporarily
(OverTemperature)
• Non-critical
Signal OVP • Overvoltage shutdown of the DC output due to high voltage entering the device or gener-
ated by the device itself due to a defect
(OverVoltage)
• Critical! The device and/or the load could be damaged
Signal OCP
• Shutdown of the DC output due to excess of the preset limit
• Non-critical, protects the load from excessive current consumption
(OverCurrent)
Signal OPP • Shutdown of the DC output due to excess of the preset limit
• Non-critical, protects the load from excessive power consumption
(OverPower)
Signal PF • DC output shutdown due to AC undervoltage or defect of the AC input circuit
• Critical on overvoltage! AC input circuit could be damaged
(Power Fail)
1.8

Technical Data

1.8.1

Approved operating conditions

• Use only inside dry buildings
• Ambient temperature 0-50°C
• Operational altitude: max. 2000 m above sea level
• Max 80% RH up to 30°C, linear decrease to 50% RH at 50°C
1.8.2

General technical data

Display: 7 segment type, 9 digits (upper row), 2x 4 digits (middle row), status symbols
Controls: 2 rotary knobs with button function, 5 pushbuttons
The nominal values for the device determine the maximum adjustable ranges.
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
PS 5000 A Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
Page 8