LaserLiner ThermoCamera HighSense Pro Aktualisierung Und Betriebsanleitung Seite 6

16.4
CustomApps: LeakageControl
16.5
CustomApps: Kaltstellen-Inspektion
16.6
CustomApps: Warmstellen-Inspektion
06
EN
LeakageControl identifies cold spots where moisture
can condense and damage from leaks may occur.
These are the points in a building which transfer heat
from inside to outside in a short space of time and
thus cool more quickly than the surrounding areas.
Early identification and treatment of these areas
prevent subsequent mildew.
ColdView-Inspection is suitable for detailed exami-
nation of cold areas. Problem points such as thermal
bridges, cold air flows or air leakages, such as around
window frames or doors, can be identified quickly
and accurately. The MIX image overlays the digital
image on the coldest 20 % of the temperature range
captured on site. The condensed colour palette pro-
vides an optimum visualisation of the precise extreme
temperature points. A standard colour palette can be
used for subsequent temperature measurement of the
extremes in order to produce a balanced colour image
for measurement and evaluation. The centre point (P1)
provides direct temperature measurement.
HotView-Inspection is suitable for detailed examina-
tion of hot areas and determination of points with pre-
dominantly high temperatures. These include heating
pipes, fuses and electrical connections. The MIX image
overlays the digital image on the warmest 20 % of the
temperature range captured on site. The condensed
colour palette provides an optimum visualisation of
the precise extreme temperature points. A standard
colour palette can be used for subsequent temperature
measurement of the extremes in order to produce a
balanced colour image for measurement and evaluati-
on. The centre point (P1) provides direct temperature
measurement.