Oase Aquarius Fountain Set Eco Inbetriebnahme Seite 11

Installation and connection
Reassembling the unit
How to proceed:
 A
1. Fit the sleeve, flow regulator, double nipple, union nut, ball joint and transition piece together
and screw onto the pump outlet.
2. Screw the telescopic extension with the desired nozzle onto the flow regulator.
3. Screw the stepped hose adapter onto the flow regulator for feeding a water course if applica-
ble.
4. Align the telescopic extension and hand tighten the union nut on the ball joint.
Installing the unit
WARNING
Severe injuries or death due to operation of this unit in a swimming pond. Defective electrical
components will electrify the water with dangerous electrical voltage.
 Never operate the unit in a swimming pond.
NOTE
If the pump is used for conveying excessively soiled water, the impeller unit will be subject to in-
creased wear and will require earlier replacement.
 Thoroughly clean the pond or pool before installing the pump.
 Install the pump at a raised level above the bottom. This reduces intake of muddy water.
How to proceed:
 B
• Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that
it is completely covered with water.
EN
11