Atag One zone Bedienungsanleitung Seite 20

Installation
Placement
Because the ATAG One Zone is influenced by room temperature, the location must be selected
carefully. Therefore, a location near potential causes of incorrect measurement should be
avoided (e.g. heating sources, draughts, windows, doors, direct sunlight).
Place the thermostat at a height of approximately 1.5 metres above the floor.
Connect the
ATAG One Zone
Before making any electrical
connections, ensure that the heat
generator is switched off.
See illustration on the opposite page (page 21).
my.atag.zone
!
NOTE! Installation must be carried
out by a qualified professional.
A Attach the ATAG One Zone wall plate
(A) to the wall, and connect the
wiring to the terminal block to make
the BUS connection.
Place the ATAG One Zone on the
B
wall plate (B) by gently pressing
the bottom after the top has been
hooked.
20