Hitachi CENTRAL STATION PSC-A32MN Bedienungsanleitung Seite 6

Safety summary
1 SAFETY SUMMARY
This product has been designed for air conditioning systems.
!
D A N G E R
• DO NOT pour water into the central station (hereafter called
"controller"). This product is equipped with electrical parts. If
water is poured, it will cause a serious electrical shock.
• Prior to the installation work, ensure that foundation is flat,
level and sufficiently strong and then fix the unit securely. If the
foundation is not strong enough, it may lead to injuries caused by
falling of the product, electrical shock or fire.
• DO NOT install the unit in a place where generation, flow,
accumulation or leakage of flammable gas is detected.
• DO NOT perform installation work and electrical wiring connection
by yourself. Contact your distributor or dealer of HITACHI and
ask them for installation work and electrical wiring by a trained
service person.
• Perform electrical work according to the Installation Manual and
all relevant regulation and standards. If the instructions are not
followed, electrical shock and fire may occur due to insufficient
capacity and inadequate performance.
• Use the specified cables for connection between indoor unit and
central station. Selecting incorrect cables may lead to fire or
electrical shock.
• Turn OFF the main power supply entirely before opening or
closing the service cover of the indoor unit, since the power
terminal or the power switch part may otherwise be still powered
on and cause an electrical shock. Turn OFF the main power
supply also when performing wiring works.
• When performing local wiring work, check whether the local
wiring has been gnawed by animals like mice or small rodents.
Gnawed wiring could cause a fire.
2 COMPONENTS LIST
When unpacking Central Station PSC-A32MN, check that it has not suffered damage during transport.
Check to ensure that the following parts are packed with the central station.
Name
Central station PSC-A32MN
M4x16L screws
Touch pen
Touch pen holder
USB stick memory
Instruction manual
Connector Cord
Closed End Connector
Nylon Band
1 PMML0364B rev.0 - 05/2015
!
C A U T I O N
• DO NOT install the indoor unit, outdoor unit, central station and cable
in the following places;
- Where oil vapour or oil is dispersed (It may cause a fire,
deformation, corrosion or failure.)
- In the vicinity of hot springs (in a sulphuric environment)
- In the vicinity of the sea (in a salty environment, which may cause
corrosion.)
- In an acid or alkaline environment
- At the reach of children
- Under direct blow of discharge air from the unit
- In places with humid atmosphere
- In places where the unit may get wet
- In poorly ventilated places
• DO NOT install the indoor unit, outdoor unit, central station and cable
within approximately 3 metres from strong electromagnetic wave
radiators such as a radio.
• In case that the central station is installed in a place where
electromagnetic wave radiation is generated, shield the central station
and cables by covering the unit with a steel box and running the cable
through a metal conduit tube.
!
C A U T I O N
• This appliance must be used only by adult and capable people,
having received the technical information or instructions to handle this
appliance properly and safely.
• Children should be supervised to ensure that they do not play with the
appliance.
Quantity
1
4
2 For activating/deactivating the touch options on the screen.
1 For holding the touch pen on the central station.
1 With the detailed Installation and operation manual
1
Basic instructions for the installation of the device.
3 For using external input/output functions (CN1~3).
9 For closing the wire end of the connection cord.
3
Comments
For controlling system operation
For fixing the central station.
For fixing the cables.