Bestway PowerGrip 62265 Gebrauchsanweisung Seite 2

OWNER'S MANUAL
Model No. 62265
NOTICE: READ CAREFULLY BEFORE OPERATING AND SAVE THESE INSTRUCTIONS.
CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO WATER OR RAIN.
WARNING
• If instruction is missed, please contact with Bestway or search it in website: www.bestwaycorp.com
• Do not use the pump continuously for more than 15 minutes. It can only be used again after at least
30 minutes of cooling.
• It must only be supplied at SELV.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
DISPOSAL
Electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
TECHNICAL SAFETY INSTRUCTIONS
• To avoid the risk of electric shock, do not use damaged power cords. Damaged power cords should be
discarded. Do not attempt to repair damaged power cords.
• The pump can only be used with the attached car plug.
• This product may only be used with the original hose.
• Inflation and deflation ports should be kept free of debris during use.
• Never leave the pump unattended while the pump is in use.
• The product cannot be used in a flammable or explosive environment.
• Adapted air pressure of this pump is 0.5 -16 PSI.
• According to the standard of EN ISO 2151, the tested load acoustic power value of the device during
operation is 97dB, the sound pressure value is 85dB, and the uncertainty is 3dB.
• IMPORTANT: When inflating the SUP board, it is recommended to keep the car on. This will increase
the battery's output and the pump's performance.
• If the pump cannot inflate the SUP board to the set pressure, the car battery is not strong enough.
• Please use this equipment at ambient temperature of no more than 40 °C/104 °F.
• The auto-stop function does not work with products such as air mattresses, or with products with a
standard pressures below 1 PSI or 705 mmH2O. Set the pressure to 5 PSI to inflate these products and
activate the pump manually, and stop the inflation when the product is firm. In case the product is
over-inflated, it could be damaged or permanently deformed.
• Switch off the pump and disconnect the pump from the power supply before maintenance.
2