VOSS.farming easyCUT pro Bedienungsanleitung Seite 26

All manuals and user guides at all-guides.com
9.2 SHARPENING BLADES
CAUTION
The sharpening of the blades may only be carried out by specialist dealers using
specialist equipment. Do not sharpen the blades yourself.
10 TROUBLESHOOTING
NOTICE
► Do not make any improper changes or modifications to the unit.
► Never open the housing. Contact the service department for repairs.
If the device malfunctions or is found to be otherwise defective, even after following
the suggested solutions below, contact the service department. The contact details can
be found in chapter 14.
Fault/Problem
Motor does not run
Motor gets hot
Motor vibrates
Motor is very loud
Motor runs very
slowly
26
INSTRUCTION MANUAL VOSS.FARMING EASYCUT PRO
Motor
Cause
1. No current
2. Cable, Switch or
motor defective
1. Air filter clogged
2. Blade tension is too
high
3. Blade and/or head
are dry
4. Defective ball
bearing
1. Rotor runs out of
round
2. Bearings are worn
out
3. Fan wheel broken
Bearings seized up
1. Carbon brushes
worn out
2. Defective rotor or
stator
Solution
1. Check the socket and fuse used
and have them checked/replaced
by qualified personnel if necessary.
2. Contact the service department.
1. Clean or replace the air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this
solves the problem
machine stops cutting, the blades
must be sharpened.
3. Lubricate the blades/ clipper head.
4. Contact the service department.
Contact the service department.
Contact the service department.
1. Change the carbon brushes.
2. Contact the service department.
and the
85290 - 07.2021 - V5