Makita LS1110F Betriebsanleitung Seite 17

9. Check the saw blade carefully for cracks or
damage before operation. Replace cracked
or damaged saw blade immediately. Gum and
wood pitch hardened on saw blades slows saw
and increases potential for kickback. Keep saw
blade clean by first removing it from tool, then
cleaning it with gum and pitch remover, hot
water or kerosene. Never use gasoline to clean
saw blade.
10. While making a slide cut, KICKBACK can
occur. KICKBACK occurs when the saw
blade binds in the workpiece during a cutting
operation and the saw blade is driven rapidly
towards the operator. Loss of control and
serious personal injury can result. If saw blade
begins to bind during a cutting operation,
do not continue to cut and release switch
immediately.
11. Use only flanges specified for this tool.
12. Be careful not to damage the arbor, flanges
(especially the installing surface) or bolt.
Damage to these parts could result in saw
blade breakage.
13. Make sure that the turn base is properly
secured so it will not move during operation.
Use the holes in the base to fasten the saw to a
stable work platform or bench. NEVER use tool
where operator positioning would be awkward.
14. Make sure the shaft lock is released before the
switch is turned on.
15. Be sure that the saw blade does not contact
the turn base in the lowest position.
PARTS DESCRIPTION
► Fig.2
1 Adjusting screw (for
lower limit position)
5 Pointer (for bevel angle)
9 Sliding fence
13 Turn base
17 Adjusting bolt (for turn
base)
21 Blade guard
25 Hole for padlock
► Fig.3
1 Lamp switch
5 Set plate
9 Releasing button (for
bevel angle)
2 Stopper arm
6 Bevel angle scale
10 0° adjusting bolt (for
bevel angle)
14 Miter angle scale
18 Lock lever (for turn base)
22 Lamp
26 Lock-off button
2 Shaft lock
6 Hex wrench
- -
16. Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
17. Make sure the saw blade is not contacting the
workpiece before the switch is turned on.
18. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced saw blade.
19. Stop operation immediately if you notice any-
thing abnormal.
20. Do not attempt to lock the trigger in the "ON"
position.
21. Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
22. Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala-
tion and skin contact. Follow material supplier
safety data.
Additional safety rules for operating lamp
1. Do not look in the light or see the source of
light directly.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
3 Dust bag
7 Slide pole
11 Guide fence
15 Pointer (for miter angle)
19 Grip (for turn base)
23 Handle (for operation)
27 Carry handle
3 Adjusting bolt (for maxi-
mum cutting capacity)
7 45° adjusting bolt (for
bevel angle)
- -
17 ENGLISH
DO NOT let comfort or familiarity
4 Thumb screw (for car-
riage sliding)
8 Vertical vise
12 Sub base
16 Kerf board
20 Dust collecting guard
24 Switch trigger
- -
4 Stopper pin (for carriage
elevation)
8 Lever (for bevel angle)
- -