Herunterladen Diese Seite drucken

Brusa BCM98 Betriebsanleitung Seite 10

Werbung

Betriebsanleitung BCM98
7
Die Menupunkte /
The menu items
10.2001
Shuntfaktor:
Im Menupunkt Shunt kann der Shunt-Faktor
gewählt werden.
Der Shuntfaktor wirkt sich auf alle Grössen aus,
die über den Shunt gemessen werden.
Autoreset-Funktion:
Im Menupunkt Auto kann der Autoreset und die
Hysterese für Autoreset ein- oder ausgeschaltet
werden.
Es existieren drei Einstellungen für die Autoreset-
Funktion:
"NOAUTO" = kein Autoreset
"AUTO"
= normales Autoreset
"AUTOHY" = Autoreset mit 1A Hysterese
WARNUNG: Der Ah-Zähler wird bei einge-
schalteter Hysterese nicht korrekt zurückgesetzt,
wenn eine grosse Ladung bei einem Strom unter
1A aus der Batterie entnommen wird !
Wahl der Art des Analogkanals:
Unter den Menupunkten PWM0 und PWM1 kann
die Art des Analogkanals gewählt werden.
"DEFLT" bedeutet:
Bei PWM0: Neg-Out
Bei PWM1: NAR-In
Neg-Out= geschalteter Ausgang bei
negativem Ah-Zähler
NAR-In = Kein Autoreset, falls extern
eine Last beschaltet wird.
Minimalwert des Analogkanals:
MIN0, MIN1: Untere Grenze des dargestellten
Analogbereichs.
10 / 18
User's manual for BCM98
Shunt factor:
In the menu item Shunt you may change the shunt
factor.
The shunt factor has an effect to all values
measured over the shunt.
Autoreset function:
In the menu item Auto you may switch on and off
the autoreset and the Hysteresis for the autoreset.
There are three possible combinations for the
autoreset function:
"NOAUTO" = no autoreset
"AUTO"
= normal autoreset
"AUTOHY" = autoreset with 1A hysteresis
WARNING: The Ah-Counter is not reset correctly,
if the hysteresis is enabled and a big amount of
charge is used out of the battery with a current
smaller then 1A !
Selecting the type of an analog channel:
In the menu items PWM0 and PWM1 you can
select the type of the analog channel.
"DEFLT" means: At PWM0: Neg-Out
At PWM1: NAR-In
Neg-Out= Output will be switched when
Ah-counter is negative.
NAR-In = No autoreset in the case any
load is connected.
Minimum value of the analog channel:
MIN0, MIN1: Lower limit of the analog range to be
displayed.

Werbung

loading