Settings Menu; General Overview - GOVECS FLEX 2.0 Bedienungsanleitung

USING THE NFC CARD
Turning the scooter ON
1� Get near the scooter and press the Start/Stop button�
2� The Start/Stop button is in red colour displayed�
3� Hold the NFC card close to the NFC card receiver on the
bottom of the cockpit�
4� The Start/Stop button is in blue colour displayed�
5� Make sure the side stand is folded so that the "sidestand
out" warning signal is not active�
6� The scooter is then ready to drive�
Turning the scooter OFF
1� Drive your scooter to a safe parking position�
2� Press the Start/Stop button firmly to put the scooter
system to sleep mode�
3� Hold the handlebar firmly and get off the scooter�
4� Unfold the side stand (or the central stand)�
5� Turn the handlebar all the way to the left (the scooter is
equipped with an automatic steering lock that protects
the scooter from theft)�
6� The Start/Stop button light goes out�
14
IGNITION
Start/Stop button

SETTINGS MENU

GENERAL OVERVIEW

To access the settings menu press the "Mode" button on the handlebar of the scooter continuously, until the screen changes� To
make use of it, the "Mode" button is used to navigate through the menus and the "Horn" button to enter a sub-menu and confirm a
selection�
The settings menu has 4 sub-menus, listed below:
1� Firmware: Provides information about the firmware versions�
2� Speed units: Switches between km/h and mph�
3� Time: Switches between summer time and winter time�
4� Key Card Pairing: Lets the user control the paired NFC keys with the scooter�
In the following picture the overview of the menu in the cockpit is shown:
EN
15