Vaporesso XROS 3 Bedienungsanleitung Seite 4

ENGLISH
USER INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and install the new one.
*If it's the first time using the device, please tear off the sticker of the pre-
installed pod.
2. Fill the E-liquid （ Refer to FIGURE1 ）
Snap off the mouthpiece then squeeze the e-liquid through filling slot. After
filling, put the mouthpiece back and make sure it's shut firmly.
*If it's the first time filling the e-liquid, please wait 5 minutes for the coil to
prime.
3. Adjust Airflow （ Refer to FIGURE2 ）
There is an airflow control toggle on the back of the battery. Adjust the toggle
according to your vaping habits for different airflow effects.
4. Power ON/OFF
Click the power button 5 times in 2 seconds to power on or power off the
device.
5. Start Vaping
The device is both button-activated and draw-activated. Press the power
button or inhale directly through the mouthpiece and exhale to start vaping.
The LED indicator will flash in a neon sign during vaping.
6. Check the Battery Level
The LED indicator will stay in green/blue/red color to show the battery level
after vaping or inserting the pod.
Battery Level LED Color
70%~100% Green
30%~70% Blue
0~30% Red
7. Charging
Please use the in-box Type-C cable to charge the device. The LED indicator will
breath in a neon sign while charging and stay in green while fully charged.
PROTECTIONS
Low Resistance/Short-circuit/High Temperature: The red indicator will flash 5
times and the device will stop working.
No Load/High Resistance: The current battery level indicator will flash 5 times
and the device will stop working.
Low Voltage/Over Discharging: The red indicator will flash 3 times and the
device will stop working.
Over Charging: The green indicator will stay on and the device will stop
charging.
Overtimes(8s): The device will stop working and the LED indicator will flash in
green-blue-red.
CAUTIONS
1. Please turn off the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which may cause damage.
4. Please use a standard USB output charger with proper charging current
and voltage range.
5. Keep away from the water or any flammable gas, liquid .