Changing The Fuse - Profi-Partner 41163 Bedienungsanleitung

Using the wrench
Attention:

When tightening the nuts, first screw in the nuts manually, then use the wrench to tighten it.

It is an emergency repair tool; please check the tightness situation manually after tightening it with
the wrench.

Pay attention to waterproof measures

Please tighten the wheel nuts manually after the wheel change and check them after 50-100 km
once again!
1. Park your vehicle safely on level ground, then follow the instructions to jack up the vehicle.
2. Keep the switch in "O" position
3. Insert the power cord plug into the vehicle's 12V cigarette lighter. Make sure that the red LED
indicator on the plug turns on.
4. Choose the proper socket to the wrench's shaft.(check Figure 1)
5. According to working rotation, choose the switch for loosening or tightening.(check Figure 2)
a. Press the switch to right side (with mark
two or three times of "clatter" sound.
b. Press the switch to left side (with mark
times of "clatter" sound.
Figure 1
Figure 2

Changing the Fuse:

1. Turn and remove the fuse cap and pull out the fuse.
2. Insert a new fuse inside the case and reinstall the fuse cap.
COB Head Lamp

1W COB headlamp with elastic band

Brightness in about 50LM

Mode: 100% - 50% - strobe

Material: ABS lamp case + Polyester band

Powered by 3xAAA batteries (not included)
) to loosen the nuts, and each nut will be loosened after
)to tighten nuts. It will be tight enough after two or three
GB