Profi-Partner 41163 Bedienungsanleitung Seite 29

The inflator hose is damaged or is
leaking.
The hose connector is not properly
connected to the inflatable object air inlet.
Inflator hose is
The inflator has been running too long.
hot.
Load is too heavy.
The jack is leaking hydraulic fluid
internally.
The jack motor is
The jack has not been used for a long
running but jack
time and needs to be cycled.
does not operate.
The safety valve screw is loose.
The jack Up/Down switch is set to
incorrect position.
The jack takes too The vehicle's battery voltage is too low.
long to lift the
The jack has been running too long.
load.
The jack is leaking hydraulic fluid
internally.
Ambient temperature is too low causing
jack's hydraulic fluid to thicken.
The Safety valve screw is loose.
Only the first stage The load is too heavy.
of jack's pressure
rod rises.
The Jack has been running too long.
The pressure rod The Inflator /Jack switch is either set to
does not come Off or Inflator position.
down when jack
The pressure rod is stuck.
switch is set to
Down position.
Electric Impact Wrench
Shut the engine off, put the vehicle transmission in Park position and pull the emergency break
all the way.

This electric wrench only use with 12V vehicle power systems.

Do not use the electric wrench continuously for more than 10 minutes at one time.

Do not touch the drive shaft head with hand during operation.

Take care to use the correct polarity when connecting the wrench to a vehicle's battery terminals.
For negatively earthed vehicles, always connect the red battery clip to "+" positive terminal and the
black battery clip to "-"negative terminal.

New Fuse's rated electric current should be or less than 12A.

Turn off the switch 3-5 seconds after hearing the "clatter" sound.

The impact wrench is only for emergency use. Use a professional torque wrench to recheck the
correct torque as soon as possible.

The manufacturer takes no responsibility for incorrect usage of this product and the electric wrench
is only designed to loosen and tighten the wheel nuts of vehicle.

Young children should be supervised to ensure they do not play with the appliance.
SPECIFICATIONS
 Voltage: DC 12V
 Max.Current: 12A
 Rated Power: 100W
 Max.Torque: 340N.M
Repair the hose.
Secure the nozzle to the object.
Rest the unit for 15-20 minutes.
Reduce the load by relocating the jack
to other lifting points of the vehicle.
Unit is defective. Call customer service.
Set the jack Up/Down switch to Up and
then Down position a few times.
Tighten the release valve screw.
Set the switch to the correct position.
Recharge/replace the battery.
Rest the unit for 15-20 minutes.
The unit is defective. Call customer
service.
Warm up the 2-in -1 unit for 1 hour.
Tighten the Safety valve screw.
Reduce the load by relocating the jack
to other lifting points of the vehicle.
Rest the unit for 15-20 minutes.
Set the switch to Jack position.
Loosen the Safety valve screw to allow
the pressure rod to come down.
GB