Profi-Partner 41163 Bedienungsanleitung Seite 28

8. Set the switch to "O" position. Disconnect the power cord, the machine would lock automatically and
wouldn't fall.
Lowering vehicle:
1. After changing the tyre, press
2. When the jack is completely lowed, set the machine to "O". Disconnect the power cord and collect
the cables and tools in the line winding box.
In occasion when the jack's rod is stuck at UP position:
1. Swing open the tool box and remove the hex wrench from the box.
2. Remove the rubber cap from the safety valve.
3. Insert the hex wrench inside the safety valve hex cap screw and turn the wrench counter clockwise
to loosen the screw.
4. After the jack is lowered, re-tighten the safety valve hex cap screw and cover with the rubber cap.
5. Re-store the hex wrench into the box.
B. Inflator:
1. Stop the car, tension the car brake.
2. Keep the switch in "O" position
3. Insert the power cord plug into the vehicle's 12V cigarette lighter. Make sure that the red LED
indicator on the plug turns on.
4. Swing open the tool box and pull out the air hose.
5. Choose the suitable inflatable head for different objects.
6. Adjust the function switch to "I" position. Inflate the object to the desired pressure while monitoring
the pressure level on the pressure gauge.
7. After inflating the object, set the switch to "O" position to stop the machine. Then collect and re-store
the cables and accessories into the box.
Troubleshooting
Problem Possible Cause
The two switches on 2-in-1 unit are not
set to correct position.
The power cable is not connected
securely to the vehicle's cigarette lighter
outlet.
The LED indicator on the power cable
plug is off. The power cable internal fuse
2-in-1 unit does is blown.
not turn on.
The power cable is damaged.
The vehicle's cigarette lighter outlet is
dirty.
The vehicle's cigarette lighter outlet
protective fuse is blown.
The vehicle's battery is dead.
The hose nozzle is not properly attached
to the inflatable object.
The inflator motor
The inflator hose or inflatable object has a
is running but
hole, allowing air to escape.
inflator does not
The tire is completely deflated and is
inflate the object.
separated from the rim, allowing air to
escape.
The inflator takes
The vehicle's battery voltage is too low.
too long to inflate
the object.
The inflator has been running too long.
to lower down the vehicle.
Solution
Set the switches to their correct
positions.
Press the plug inside the outlet and
make sure the LED indicator on power
cable plug is on.
Replace the fuse (15A).
Have a qualified service person to
repair cable.
Clean the outlet.
Refer to vehicle's operating manual for
fuse replacement instructions.
Recharge/replace the battery.
Secure the nozzle to the object.
Repair the hose or object.
Jack up the vehicle to release tire under
vehicle's pressure.
Recharge/replace the battery.
Rest the unit for 15-20 minutes.
GB