VOLTCRAFT LSP-1403 Bedienungsanleitung Seite 22

Live components may be exposed if covers are opened or parts are removed (unless this can be done
without tools).
Before opening it, disconnect the device from all voltage sources.
Capacitors inside the device may still be charged, even if the device has been disconnected from all volt-
age sources.
Do not switch the laboratory power pack unit on immediately after it has been taken from a cold to a
warm environment. Condensation water that forms might destroy your device. Allow the device to reach
room temperature before switching it on.
The switched-mode mains power supply generates heat during operation. Make sure it is adequately
ventilated. Do not cover the ventilation apertures of the device!
Do not place any vessels with liquids on the device
Do not leave mains power supplies and the connected consumers in operation unattended.
When working with power supplies wearing metallic or conductive jewellery, such as necklaces,
bracelets, rings etc., is prohibited.
The power supply unit is not designed for application to human beings or animals.
Never expose the device to mechanical stress. Dropping the device even from a low height may damage
it! Avoid vibrations and direct sunlight.
If you have a reason to believe that the device can no longer be operated safely, disconnect it immedi-
ately and secure it against being operated unintentionally. It can be assumed that safe operation is no
longer possible if:
- the device is visibly damaged,
- the device no longer works and
- the unit was stored under unfavourable conditions for a long period of time or
- if it has been subjected to considerable stress in transit.
You should also heed the additional safety instructions in each chapter of the operating instructions of the
connected devices.
22