Electrical Safety - Gastroback DESIGN EISMASCHINE ADVANCED CONTROL Bedienungsanleitung

28. If the power cord should overheat, stop using the appliance and
disconnect the appliance from the electrical outlet.
29. Always place and operate the appliance on an even, stable and
dry surface.
30. Dry the appliance and all accessories before connecting to the power
supply and prior to attaching the accessories.
31. Connect the mains plug to an easily accessible socket, in order
to quickly disconnect the appliance from the mains supply in an
emergency.
32. If you use an extension cord or a multi-socket unit, it must have an
appropriate power rating.
33. Keep a minimum distance of 8 cm on all sides and on top of the
appliance to walls or other objects. If the distance is too small, the
cooling capacity may be impacted.
34. Do not place the appliance in direct sunlight or close to any heat
sources, as this will hinder the cooling process.
35. After turning the appliance off, always wait at least 5 minutes until
turning it on again. Otherwise, the compressor may be damaged.
36. To avoid damaging the compressor or refrigerant circuit, never tilt the
appliance more than 45°. Never turn the appliance upside down.
37. IMPORTANT! Allow the appliance to stand upright for at least 24
hours before connecting it to a mains outlet for the first time, so that
the refrigerant can settle. The same applies if the appliance is moved
at a later date.
38. If the mixing blade gets stuck, immediately stop operation.
39. Metal objects are not allowed to be inserted into the appliance to
avoid fire and short circuit.
40. When taking out the finished yogurt, ice cream, sorbet, etc., do not
knock against the refrigeration barrel or its edge to protect the barrel
from damage.
41. Do not switch on the appliance before the ice cream bowl and (if
necessary for the food type) the mixing blade are properly installed.
26
42. The initial temperature of the ingredients should be between 10°C
and 20°C. Ingredients with too low temperature can cause uneven
mixing through early solidification.
43. DANGER OF INJURY! Do not try to remove the mixing blade
when the appliance is operating.

ELECTRICAL SAFETY

1. Ensure the rated voltage shown on the rating label corresponds with
the voltage of the power supply.
2. Do not operate any appliance with a damaged power cord or plug,
when the appliance malfunctions or has been damaged in any manner.
3. Protect the power cord against damages. Do not let it hang over
sharp edges, do not squeeze or bend it. Keep the power cord away
from hot surfaces and ensure that nobody can trip over it.
4. Do not open the housing under any circumstances. Do not insert
fingers or foreign objects in any opening of the appliance and do
not obstruct the air vents.
5. Protect the appliance against heat. Do not place close to open flames
or heat sources such as stoves or heating appliances.
27