General Information - Helios Fws 2 Montage- Und Betriebsvorschrift

Installation and Operating Instructions
CHAPTER 1
GENERAL
INFORMATION
m
DANGER
m
WARNING
m
CAUTION
ATTENTION
Fireman's switch FWS 2
INSTALLATION AND OPERATING INSTRUCTIONS
1.1 Important information
In order to ensure correct operation and for your own safety,
please read and observe the following instructions carefully
before proceeding. Relevant national standards, safety
regulations and provisions (e.g. DIN EN VDE 0100) as well
as the technical connection conditions of the energy supply
company must be observed and applied. Keep the operating
instructions close to the unit for reference.
1.2 Warning and safety instructions
The adjacent symbol is a safety-relevant prominent warning label. All safety re-
gulations and/or symbols must be absolutely adhered to, so that any dangerous
situation is avoided.
m
DANGER
Indicates dangers which will directly result in death or serious injury if the safety inst-
ruction is not followed.
m
WARNING
Indicates dangers which can result in death or serious injury if the safety instruction
is not followed.
m
CAUTION
Indicates dangers which can result injuries if the safety instruction is not followed.
ATTENTION
Indicates dangers which can result in material damage if the safety instruction is not
followed.
1.3 Warranty claims – Exclusion of liability
Our warranty shall not apply if the following instructions are not observed. The same
applies for liability claims against the manufacturer. The use of accessories, which are
not recommended or offered by Helios, is not permitted. Any damage that may occur is
not liable for warranty.
1.4 Regulations – Guidelines
If the product is installed correctly and used to its intended purpose, it conforms to all
applicable regulations and EU guidelines at its date of manufacture.
1.5 Receipt
The delivery includes the fireman's switch: FWS 2
Please check delivery immediately on receipt for accuracy and damage. If damaged,
please notify the carrier immediately. In case of delayed notification, any possible claim
may be void.
1.6 Storage
When storing for a prolonged time the following steps are to be taken to avoid damaging
influences:
Protection by dry, air-dustproof packing (plastic bags with drying agent and moisture
indicators). The storage place must be waterproof, vibration-free and free of tempera-
ture variations. Damages due to improper transportation, storage or commissioning are
verifiable and not liable for warranty.
1.7 Unit versions
The Helios fireman's switch is available in the following version:
Fireman's switch 2
Type:
Description:
FWS 2 / Ref. no.: 8255
Fireman's switch with bracket for on-site DIN profile half cylin-
der, LED display and reset button
1
EN
Fig.1