GLOBBER E-MOTION 6 Benutzerhandbuch Seite 9

7 - MAINTENANCE
• Warning! As with any mechanical component, your product is subject to high stresses and wear. The various materials and
components may react differently to wear or fatigue. If the expected service life for a component has exceeded, it may break
suddenly, thereby risking injuries to the user. Cracks, scratches, and discoloration in the areas subject to high stresses indicate
that the component has exceeded its service life and should be replaced.
• Caution: The rear wheel has a motorised part; if you wish to check the rear wheel or change it, contact a qualified technician or a
Globber representative at contact@globber.com.
• If you wish to check or change any motorised parts yourself, contact a qualified technician or a Globber representative at
contact@globber.com.
• The lithium battery: To guarantee the battery lifetime, charge it when its level is low. If it is not used for a long period of time, you
are advised to charge it once a month. If you wish to check the battery or change it, contact a qualified technician or a Globber
representative.
The recommended storage temperature for the battery is between 5°C and 30°C.
• Do not use or place the electric scooter in an environment where the temperature exceeds 40°C to avoid any lithium battery
malfunction, which may lead to it catching fire.
• Never store the electric scooter in a car during hot weather to avoid any danger of this.
• Bearings: Avoid riding through water, oil, or sand, which would damage your bearings. To maintain your bearings, check regularly
that the front wheel turns properly by turning the electric scooter upside down and pushing the wheel with your fingers. If the
front wheel does not turn, remove it, and check the condition of the bearings. First unscrew the wheel axle. Remove the axle and
remove the wheel. Carefully push the two bearings out of their seating. If they are chipped or crushed, buy new ones. If there is
no visible damage, oil them. To do so, remove any traces of grease, mud, or dust from the bearing using a paper towel or a cloth;
then, grease them either with a self-lubricating spray or by soaking them in oil overnight (turn the bearings several times in the oil
before leaving them to soak). Refit the bearings, axle, and then the front wheel.
• The wheels: The wheels wear out over time or may even develop holes if the scooter is used on rough surfaces too often. This is
particularly true of the rear wheel on which the brake is applied. Check them regularly and have them changed for better safety.
• Product modifications: The original product must by no means be modified except for the maintenance-related changes
mentioned in these instructions.
• Nuts, axles and other self-locking fasteners: These should also be checked regularly. They can become loose over time, in which
case they should be tightened. They can become worn and not tighten properly, in which case they should be replaced.
8 - DISPOSAL OF END-OF-LIFE APPLIANCE
• The appliance must be disconnected from the main power supply when removing the battery.
• The battery must be removed from the appliance before the appliance is discarded.
• The battery must be disposed of safely by taking it to a suitable collection point.
ENGLISH
9