GLOBBER E-MOTION 6 Benutzerhandbuch Seite 6

MODE
On the rear right side of the deck, there is a switch button showing «1 / 2». This is for switching the speed between mode 1 (6 km/h)
and mode 2 (10 km/h).
- Mode 1: Switch the mode button to "1"; the scooter is now set to the 1st speed mode with a maximum speed of 6 km/h.
- The side LED lights and battery gauge light will flash.
- Mode 2: Switch the mode button to "2"; the scooter is now set to the 2nd speed mode with a maximum speed of 10 km/h.
- The side LED lights will flash slowly, and the battery gauge light will remain lit.
- Kick scooter mode: You can simply ride on it like a normal scooter, even when it runs out of battery.
START-UP
You are in a position to start:
To engage the motor, 3 actions are necessary.
1. Place your foot directly on the deck.
2. Push your scooter to reach a speed of 3km/h.
3. Press the accelerator button on the top of the T-bar.
Be aware that once your motor is turned ON, reducing your speed below 3 km/h does not automatically cut the motor; see
paragraph STOP regarding the instructions for stopping the motor completely.
CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake located at the rear of the scooter (mudguard) and/or
use the accelerator/throttle button located on the right-side of the T-bar (press with your thumb to accelerate; release the pressure to
slow down).
- Once the electric motor is engaged, it will accelerate until reaching the cruising speed of 6 km/h or 10 km/h, depending on which
mode (1 or 2, respectively) you are using.
- You can control the speed with the electronic brake located at the rear: Pressing this brake automatically stops the motor. The
system generates both mechanical and electrical braking that reduces again the braking distance.
- WARNING! Engaging the brake (mudguard) automatically shuts off the motor but only while you press the brake. If you release
the brake, the motor automatically engages again.
STOP
To stop the scooter completely, press the brake continuously for 3 seconds and wait for the scooter to stop safely to get off the deck.
You can remove your thumb from the throttle button to automatically shut down the motor, for example in an emergency. The battery
will automatically turn itself off when the motor is not engaged for more than 60 seconds.
5 - CHARGING
Low battery level: When the battery gauge light turns to red, the E-MOTION 6 has less than 20% battery life and needs to be
charged. When the device is low on power (i.e., the battery gauge light is red), damage is likely to occur. This can impact the service
life of the battery.
Before charging, please read the following instructions:
- This appliance can be used by children aged 8 years and above and by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance
in a safe way and under the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance should not be done by children without supervision.
- Warning: The charger (model ref. JY15-160-060) is specific for lithium battery 14.4V and 2.9Ah (model no.: 4S1PSCOOTER29E).
- The battery charger has an LED indicator: The GREEN light indicates the battery is fully charged or disconnected; the RED light
indicates the battery is low or in charging.
- Batteries are only to be charged by adults or by children at least 8 years old.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Do not recharge non-rechargeable batteries. It may cause an explosion.
- Battery chargers used with the toy should be regularly examined for damage to the cord, plug, enclosure, and other parts.
ENGLISH
6