Kenwood KDV-S250P Bedienungsanleitung Seite 22

Troubleshooting Guide
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
?
The sound/picture skips on a DVD/VCD/CD.
✔ The disc is scratched or dirty.
☞ Clean the disc, referring to the section on
<Handling discs> (see page 5).
?
A VCD cannot be played using menus.
✔ The VCD disc being played is not compatible with
P.B.C.
☞ Menu playback is available only with VCD discs
recorded with P.B.C.
?
The subtitle is not displayed.
✔ The DVD disc being played does not contain the
recording of subtitles.
☞ The subtitle cannot be displayed when the
DVD disc being played does not contain the
recording of subtitles.
?
The voice (or subtitle) language cannot be
changed.
✔ The DVD disc being played does not contain the
recording of more than one audio (or subtitle)
language.
☞ The voice (or subtitle) language cannot be
changed when the DVD disc being played does
not contain the recording of more than one
voice (or subtitle) language.
?
The unit cannot be remote-controlled.
✔ The Remote Control Sensor connection to the unit is
inadequate.
☞ Insert the Remote Control Sensor plug firmly into
the jack at the back panel of unit.
22
|
KDV-S250P
The messages shown below display your
systems condition.
"Thermal Protect. Off Power!"
: The protective circuit in the unit activates when the
temperature inside the DVD player exceeds 60°C (140°F),
stopping all operation.
➪ Cool down the unit by opening the windows or turning
on the air conditioner. As the temperature falls below
60°C (140°F), the disc will start playing again.
To eject the disc in this situation, turn the power off and
then turn it back on.
"NO DISC"
: No disc is inserted in the unit.
"THIS DISC MAY NOT BE PLAYED IN YOUR REGION"
: A DVD with the wrong region code was inserted into the
unit.
"Unknown DISC"
: A disc that cannot be played in the unit was inserted.
: The disc inserted contains damaged or non-standard data.
"PASSWORD IS DIFFERENT!"
: The password entered does not match the one registered.
: Appears if the second new password entered does not
match the first one when changing the password.
➪ When you enter the new password, you are required to
enter the same password twice for confirmation.