Kenwood KDV-S250P Bedienungsanleitung Seite 20

Installation
Installation using the brackets
Installation board, etc.
(thickness : 19 mm or more)
Installation using the velcro tapes
Carpet
20
|
KDV-S250P
Tapping Screw 5
(Φ5 x 20 mm)
Semusu Screw 4
(M4 x 5 mm)
Bracket 3
Velcro tape 6
¤
• Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
• Do not install the unit to an unstable place and a place
where it vibrates.
• When making a hole under a seat, inside the trunk, or
somewhere else in the vehicle, check that there is nothing
hazardous on the opposite side such as a gasoline tank,
brake pipe, or wiring harness, and be careful not to cause
scratches or other damage.
• Do not install near the dashboard, rear tray, or air bag safety
parts.
• The installation to the vehicle should securely fasten the
unit to a place in which it will not obstruct driving. If the
unit comes off due to a shock and hits a person or safety
part, it may cause injury or an accident.
• After installing the unit, check to make sure that electrical
equipment such as the brake lamps, turn signal lamps and
windshield wipers operate normally.
• You can mount the unit at any angle between the regular
horizontal position and the vertical position on its back (0°
through 90°). You cannot mount the unit with the disc slot
facing downwards, angled or upside down.