Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
1.
Remove the kettle from the base (6), open the lid (1), and fill the appliance with cold water within the
permitted maximum only. If the water level in the kettle is under the recommended minimum, the ket-
tle will keep overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn off automatically
2.
Place the kettle on the base (6); electric contacts will get connected automatically. Thanks to the central
connector design, the kettle can turn around 360° and be put on the base from any side.
3.
Connect the base to the mains.
4.
Turn the kettle on by pressing the switch (5).
A control light on the switch (2) signals the kettle is in operation. The kettle lid (1) must be properly closed
when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed. Hot steam could scald you!
5.
After the boiling point has been reached, the kettle will turn off automatically, and the operating light
will go out. Water heating can be terminated prematurely by moving the switch (5) to the off position.
6.
Remove the kettle from the base (6) and use the hot water.
7.
If you want to reheat the water you have just finished boiling, wait for approximately 30 seconds before
reactivating the switch (5).
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (6). It is
a small amount of condensed steam, which deactivates the kettle thermostat.
CLEANING AND MAINTENANCE
Warning!
• Prior to each cleaning operation disconnect the lead-in cable of the
appliance from el. socket!
• Prior to start any handling operation, make sure that the appliance is
cooled down!
• Use only a wet rag for cleaning surface of the appliance, do not use any
cleansers or hard things which could damage the surface!
• Never clean the appliance under running water, never flush it and
never immerse the appliance into water!
Scale removal
During common use water impurities are deposited. Use commercially
available agents for scale removal (observe manufacturer's instructions).
Note: Remove the deposits regularly, once a week as a rule – periodicity depends on water hardness and on
frequency of kettle use. The deposits reduce efficiency and service life of the appliance materially.
Lack of maintenance can cause appliance's seal or heating element damage.
Defects caused by lack of maintenance are not covered by warranty.
RK 0030
EN
25
Werbung
