Bestway 58366EU Bedienungsanleitung Seite 5

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure nothing is damaged. If
equipment is damaged,immediately notify the retailer from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete slab. Position the sand filter
so the Ports and Control Valve are accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on ground or a certain
pedestal made of wood or concrete before use to prevent the sand filter from accideutally falling. Fully
assembled sand filter will exceed 18kg. The mounting holes should be 8mm in diameter and spaced
86mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to fasten the sand filter to the
pedestal.
Load pool-grade filter sand.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85mm,
approximately one 35kg bag should suffice.
If you do not use the recommended size of filter sand, filtering performance will be reduced and thesand filter
may damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse
the Skimmer on the Hub.
NOTE: SAND NOT INCLUDED.
S-S-005014/21.0x28.5cm/58366EU / 2000gal 欧规砂滤器说明书/JS-YF-2016-B-08884-英
C
5
86mm
Ф8mm
4
MAX.
MIN .
MAX
MIN
C
C
S-S-005014