Salda RIS 700 PE 4.5 EKO 3.0 Bedienungsanleitung Seite 33

EN
Installation
Using provided template, at the intended location screw the self-threading screws leaving gap of approximately
1 mm from the plane.
2. Connect the cable to the controller
2.1- standard connection
PIN1 - +24V
1 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
PIN1 - +24V
1 2 3 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
2.2 - spec connection (see "8 pin connection").
3. Attach the controller by positioning it rotated to the left at the angle of 25°.
4-5. Turn the controller to the right until the controller contacts the plane. Remove the used template.
8 8 pin connecti
Only competent electrician is allowed to make electrical connections in accordance with the applicable interna-
tional and national electrical safety and electrical equipment installation requirements.
1. Power supply 24V AC/DC, 100mA
2. Power supply 24V AC/DC
3. GND
4. RS485 B (Modbus)
5. RS485 A (Modbus)
6. GND
7. 0-10VDC input (used for pressure or CO2 sensor). The sensor is powered from a separate power source.
8. 0-10VDC output (used for control of 0..10 VDC fans.
www.salda.lt
tion
27