Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly (You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure
nothing is damaged. If equipment is damaged, immediately notify the
retailer from where the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and Control Valve are
accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on ground or a
certain pedestal made of wood or concrete before use to prevent the sand filter from
accideutally falling. Fully assembled sand filter will exceed 18kg. The mounting holes
should be 8mm in diameter and spaced 86mm apart. Use two bolts and nuts with a
maximum of 8mm in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 20kg bag should suffice. If you do not use the
recommended size filter sand, filtering performance will be reduced and the sand filter may
damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom
Tank to submerse the Skimmer on the Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
S-S-006164/21.0x28.5cm/58495GS / 1000gal 德规砂滤器说明书/JS-YF-2017-B-03641-英
4
C
5
86mm
Ф8mm
MAX
.
MIN
.
MAX
MIN
C
C
Werbung
