EINHELL TE-DH 5 Originalbetriebsanleitung Seite 13

4. Technical data
Mains voltage: ................... 220- 240 V ~ 50/60Hz
Power input: .............................................. 750 W
Blow rate: ............................................. 4300 rpm
Tool chuck: ...........................................SDS-Plus
Protection class: ............................................ II/
Weight: .......................................................3.9 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ..................... 93.8 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ...................... 104.8 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Chiseling
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Anl_TE_DH_5_SPK13.indb 13 Anl_TE_DH_5_SPK13.indb 13
= 17.2 m/s
2
h
2
- 13 -
GB
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2 – Item 4)
For safety reasons you must use the demoli-
tion hammer only together with the additional
handle.
The additional handle (4) lends you additional
stability while using the demolition hammer. For
safety reasons the tool is not allowed to be used
without the additional handle (4).
The additional handle (4) is secured to the de-
molition hammer by a clamp. Turning the handle
anti-clockwise (viewed from the handle) will re-
lease the clamp. Turning the handle clockwise will
tighten the clamp.
First release the clamp of the additional handle.
Then you can swivel the additional handle (4)
into the most comfortable working position for
yourself. Now turn the additional handle in the op-
posite direction again until the additional handle
is secure.
30.09.2021 15:01:41 30.09.2021 15:01:41