Error Codes; Console; Programs - VirtuFit Run Fit Foldable Bedienungsanleitung

ENGLISH
Power failure: Check that the sensor cable is properly connected.
Safety Key does not work properly: Check that the safety key is
properly attached.

ERROR CODES

"----" The signal from the safety key is not recognised by the
computer.
• Solution: Check that the magnetic points of the dongle are
correctly attached. If this does not solve the problem, contact
the supplier. If this does not solve the problem, contact the
supplier.
E07/E08: Console chip damaged.
• Solution: Contact the supplier.
CONSOLE (FIG. A)
(PROG) In manual mode, press
•
(P1 - P12) or "FAT".
(MODE) Press
• and the display lights up every 5 seconds
with the values of "SPEED", "TIME" and "CALORIES".
(START) Press
• to start the device. The appliance starts
after 3 seconds in the lowest speed or in the speed of the
standard programme.
• (STOP) Press to stop the appliance. The device will
come to a slow stop. All data will be retained.
• +/- Press to increase or decrease the speed.
• SPEED (2-4-6-8-10-12) Adjust the speed in quick increments.
Functions
TIME The total time of the workout is displayed.
•
• DISTANCE The distance covered is displayed.
• CALORIES The total calories burned during the workout are
displayed.
• PULSE When using heart rate sensors, your heart rate is
displayed during exercise. When no heart rate is detected, "P" is
•
PROGRAMS (FIG. B)
Quick start
Attach the magnetic end of the safety key to the console and press
to start the machine. The treadmill will start at the lowest speed. Press
the QUICK SPEED modes to adjust the speed. Press
safety key to stop the machine.
Countdown mode
•
•
•
•

Programs

Press
summary data. Press "SPEED" to set the duration of the workout.
to select a programme Each program is divided into 20 parts and each workout time is the
set time/20. Press
the first phase is completed, the machine automatically switches to the
next phase. In each phase the speed increases or decreases. During the
workout, the speed and incline can be adjusted by pressing "SPEED" or
"INCLINE". When the program enters the next phase, it returns to the
current speed. When the program ends, the treadmill will slowly stop.
Press
Heart Rate Test
The heart rate will be displayed after 5 seconds if the sensors are held
with both hands. To accurately measure the heart rate, first perform a
test with the unit turned off. To do this, hold the handles with the hand
sensors for more than 30 seconds. The heart rate values are given as an
example and cannot be compared with medical data.
displayed.
SPEED The speed during training is displayed.
Press to set workout time, distance or calories. The display
will show the summary data.
Press "SPEED" and "INCLINE" simultaneously to set the data and
press to start the unit.
Press "SPEED" to set the speed and "INCLINE" to set the incline.
When a program is complete, the treadmill will slowly stop.
Press or remove the safety key to stop the machine early.
to select a program (P12 to P12). The TIME display shows the
to start the machine in first speed mode. When
or remove the safety key to stop the machine early.
or remove the
13