KLEIBER KS 218-TS Betriebsanleitung Seite 9

4 Technical Data
Device type
Meas. range
Spectral range
Measurement outlet
Switching state indicator
Accuracy
Reproducibility
Response time
Switching pulse duration
Emissivity
Optic
Aiming device
Operating temperature
Storage temperature
Relative humidity
Power supply
Connection
Degree of protection
Test base
CE marking
Length
Diameter
Weight
Optics:
a
d in mm
b
m in mm
a
Distance from front of housing
b
Measuring field diameter
5 Technical Description
5.1 System Design / Principle of Operation
The KS 218 - TS or KG 218 - TS recognizes without contact hot objects located in its measuring beam, to
trigger a switch process. The switching level can be adjusted via potentiometer, the switch status is indicated
by LED. The switch is used for recognizing, counting or positioning of hot objects e.g. in forges or steel works.
The instrument is equipped with a white LED targeting light for exact alignment. During operation the LED is
always on.
The operating elements as well as the connections/interfaces are located at the back of the pyrometer (see
Operating elements (section 5.3) at page 6).
KS 218 - TS KG 218 - TS
KS 218 - TS
700 . . . 1,500 °C
0.85 . . . 1.05 m
Switch voltage when exceeding the threshold 2 V below power supply
voltage, max. 30 mA (short circuit protection)
LED at rear side
0.75 % of measured value (at 23 °C, = 1)
< 0.3 % of measured value (at 23 °C, = 1)
600 s
Time duration temperature threshold passed + 600 s (standard)
Time duration temperature threshold passed + 500 ms (option)
Fixed to 1
Fixed
LED pilot light
0 . . . +70 °C
-20 . . . +70 °C
Non condensing conditions
24 V DC ( 15 %), 60 mA
Via sensor plug 3-pol. M8
IP 54 according to DIN 40 050
EN 55 011 : 1998, limit class A
According to EU regulations
125 mm
25 mm
About 180 g
170 220 400 600
2.5 4.0 5.5 7.0
KG 218 - TS
400 . . . 1,400 °C
0.85 . . . 1.80 m
800 1,000 1,400
10.5 14.0 18.0
5 Technical Description
1,600 1,800 2,000
21.0 24.5 28.0
5