Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11 Taking out of service, Disposal
Store the pyrometer appropriately in the original packaging. Put a suitable desiccant inside the packing (e.g.
silica-gel) to prevent damage by moisture. Protect the pyrometer against dust through suitable measures.
The following climatic conditions are required in the storage room of the pyrometer:
• Temperature range -20 °C . . . +70 °C
• Maximum air humidity to 70 %
• Atmosphere free of dust and corrosive vapors
10 Maintenance and Care
10.1 General information
CAUTION:
Humidity can lead to the destruction of the electrical and electronic components!
Do not use any liquids for cleaning the pyrometer or cleaning the immediate of the pyrometer!
IMPORTANT:
The servicing period depends particularly on the operating and environmental conditions and is there-
fore to be specified by the operator!
The pyrometer is largely maintenance-free. Its function depends, however considerably on the condition of the
optics. The optics must therefore be checked and if necessary cleaned at regular intervals according to the
operating and environmental conditions (see Cleaning the Optics (section 10.2) at page 12). This is necessary
in particular if the measured temperature levels do not lie in the expected range.
In the case of excessive contamination or scratches of the optics, please contact the technical customer service
(contact address see (section 3.3) at page 4).
Check the cables and the housing at regular intervals for damage and a firm seating.
10.2 Cleaning the Optics
Clean the lens with a soft cloth or cotton pad and with white spirits. The optics is thus cleaned and the
pyrometer is again ready for use.
11 Taking out of service, Disposal
11.1 Taking out of service
DANGER:
Removing electrically live cables risks injury and damage to equipment.
Never remove electrically live connecting cables. Before removing a cable, ensure that the power
supply has been switched off.
Take the pyrometer out of operation as follows:
1. Switch off the power supply to the pyrometer
2. Remove the cables at the rear side of the pyrometer.
3. Dismantle the pyrometer from the mounting plate (when used).
The pyrometer is thus out of operation.
12
KS 218 - TS KG 218 - TS
Werbung
