Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.4 Mechanics
Numerous accessories guarantee easy installation of the pyrometers. The following overview shows a selection
of suitable accessories. You can find the entire accessory program with all reference numbers at Accessories
(section 3.3) at page 4.
5.4.1 Mounting
For easy mounting and aligning the switch to the
measured object.
Art.-No:
• 30006-32170 Mounting support, adjustable
• 30006-32120 Ball and socket mounting
• 30006-32150 Mounting with retaining pin
10 mm
5.4.2 Cooling
The completely covered cooling jacket with addi-
tional air purge unit for the optics protects the py-
rometer if exposed to a hot environment.
Art.-No:
• 30006-32250 Cooling jacket with integrated
air purge
5.4.3 Miscellaneous
The air purge protects the lens from contamination
with dust and moisture. It has to be supplied with
very clean (dry and oil-free) pressurized air and
generates an air stream shaped like a cone.
Art.-No:
• 30006-32220 Air purge unit
6 Starting Up
6.1 Installation Site Requirements
CAUTION:
Measurement errors and damage to the pyrometer through:
• ambient temperatures too high
• strong contamination of the optics due to dust, smoke, steam or other causes - air pollution
• electromagnetic interference sources
You must take into account the following climatic conditions and the requirements of the place of use
of the pyrometer!
KS 218 - TS KG 218 - TS
Figure 2: Mounting angle, adjustable, Ball
and Socket mounting, and Mounting support
with retaining pin
Figure 3: Cooling jacket with integrated air purge
Figure 4: Air purge
6 Starting Up
7
Werbung
