Cepex 059073030 Bedienungsanleitung Seite 4

2. Electrical connection
The valve is supplied with a 4 wire x 1 mm
The drawing indicates the external connection: an external relay must change the turning sense when it changes the signal
from black cable to brown cable. For changing the electrical connection of the valve, it is necessary to remove handle and cover
of the actuator to access to the connection terminal. Then, pass a 4-wire cable (through the bottom gland until the terminals
shown in the drawing).
External connection
Cams configuration for 3-way rotary disc valve turning
Resting position - Right Exit
SA
Red
SI
White
C
Blue x2
230 VAC 50 Hz
24 VAC 60 Hz
External connection
cable. You must connect it following the drawing printed in the actuator cover.
2
Grey (Neutral)
Brown
Black
3 wire cable connection
180
Switch 1 activated by lower cam
Upper cam position
Uppper cam
Lower cam
Cam positioner
degrees:
180º position - Left Exit
SA
Red
SI
White
C
Blue x2
230 VAC 50 Hz
24 VAC 60 Hz
External connection
4
ENGLISH
Switch 2 activated by upper cam
Lower cam position