Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
The cooktop must be set into a worktop between 20
mm and 50 mm deep.
• There must be nothing between the cooktop and
the oven (cross rails, brackets, etc.).
• The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 20 mm.
• If the cooktop is to be installed next to a column
unit, leave a distance of at least 100 mm from the
edge of the cooktop to the side of the column unit.
• For built-in dimensions and installation see the
pictures in this paragraph.
• A minimum distance must be maintained between
the hob and the hood above it. Please refer to the
user manual of the hood for more informations.
515
270
+1
0
PLACING THE HOB
After the electrical connection (see the chapter
"Electrical connection"). Position each fixing clips on
the dedicated slots on the lateral sides of the hob as
30 mm
40 mm
289
+1
490
5
R
MAX
• Apply the supplied gasket to the cooktop (unless
it has already been fitted), after having cleaned its
surface.
• Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do
not come into contact with steam or moisture, which
could damage them.
• If an oven (from our range of ovens) is installed
beneath the cooktop, make sure that it is equipped
with a cooling system. If the temperature of
the electronic circuits exceeds the maximum
permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes
until the internal temperature of the electronic
circuits reaches a tolerable level, at which point it will
be possible to switch the hob on again.
57
0
shown in the picture. Then push the hob inside the
cut out and check that the glass is flat and parallel to
the worktop. The fixing clips are designed for every
type of worktop material (wood, marble, etc).
EN
11
Werbung
