NAMCO TOKYO WARS SD Bedienungsanleitung Seite 30

6-6 Linking Two Machines
1. Ensure that the power is OFF.
2. Loosen the two pozi head screws retaining the link cover bracket, located
next to the mains-in socket on the rear of the machine, and remove the
link cover bracket.
3. Use the supplied link cables to connect each link board. (See Diag.)
ON
OFF
4. Set the link switches to "ON", "EXT" and "ON".
Link Switches")
5. Refit the link cover bracket, passing the link cables through the slots in
the cover bracket.
6. Turn the power to the machine "ON" and set the PCB ID settings.
to Section 6-3-2 "Game Options" item (a).)
6-6-1 Setting the Link Switches
The link switches are for setting the connection between machines or seats.
Setting for one Machine
ON
OFF
INT ON
EXT OFF
IN OUT
(2 seats)
INT ON
EXT OFF
IN OUT
Page 30
ON INT ON
OFF EXT OFF
(Refer to 6-6-1 (below) "Setting the
Setting for two Machines
(4 seats)
ON INT
OFF EXT
(Refer
ON
OFF