NAMCO TOKYO WARS SD Bedienungsanleitung Seite 18

4. MOVING THE MACHINE
This machine is fitted with castors to make it easier to move. Take care
when moving the machine on an inclined surface.
The overall height of the machine, with the Header Assembly fitted, is
2050mm. Take care of any overhead obstructions. (e.g. Light Fittings,
Electric Cables etc.)
5. INSTALLATION
NEVER turn the power to the machine ON until installation has been
completed.
In order to prevent possible electric shocks, be sure that the machine is
connected to the mains with a securely connected earthed plug.
In order to avoid damage to the machine due to mis-operation, ensure that the
voltage of the mains supply is 230volts AC.
Note: If the location of this machine has a polished floor, it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor.
Note: In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall or
other machine by at least 500mm
This machine is designed for INDOOR USE ONLY.
1. Outdoors
2. Direct Sunlight, places with excessive humidity or dust, places where there is
water leakeage, near air-conditioning or heating equipment, places with
excessive heat or cold temperature.
3. Places where it would be in the way of emergency exits or fire extinguishing
equipment.
4. Unstable places or places with excessive vibration.
5. Places that are not level.
MOVING THE MACHINE
NOTES ON INSTALLATION
Do not install in the following places.
Page 18