Polaris 380 Bedienungsanleitung Seite 6

Fine Tuning The Polaris Cleaner
When operating correctly, the Polaris 380 vacuums, sweeps and scrubs all surfaces randomly throughout the
pool. Approximately every three minutes the Polaris 380 goes into back-up mode. This action pulls the Polaris
away from pool obstacles and increases its random pattern.
Thrust Jet Adjustment
The thrust jet powers the direction of the Polaris. Factory position is
eleven o'clock, but depending on the pool, other settings are helpful.
Sweep Hose Adjustment
The sweep hose should move in a gentle sweeping motion. To adjust,
turn off the booster pump and turn the sweep hose adjustment screw.
Turn clockwise to decrease the motion.
Routine Maintenance
Cleaning the Bag
Remove the bag collar from the feed hose and depress the prongs to release the bag from the cleaner. Open
the bag closure and dump out the debris.
Empty the filter bag when it is half
full, especially if the dirt load is
sand.
It is easier to empty the filter bag
when it is dry. Alternate between
two bags.
Cleaning the Filters
Always disconnect the Polaris before cleaning or
backwashing the pool filter, and let the filtration
system run for at least five minutes before
reconnecting the cleaner.
To clean the in-line filter screen, pull it out of the
filter assembly, rinse it and press it firmly
back into place
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water (freeze damage is
not covered under the warranty). Remove the UWF from the pool wall by attaching the Quick Disconnect and
using pulling pressure to unscrew. If necessary, use the UWF Removal Tool (part #10-102-00) available from
any authorized Polaris dealer.
Zipper
Closure
Bag Collar
www.polarispool.com
12
11
9 3
6