Icy Box IB-RP105 Schnellinstallationsanleitung Seite 7

Quick installation guide IB-RP105
Important product information
Dear customer, please note the following information about the main boards
which are supported by this device!
Requirements and information
• Compatible with: Raspberry Pi
B and Model B+
• No GPIO cable cut out, and no antenna hole cut out, no status LED cut
out for Pi
®
• Raspberry Pi
Packing content
1x IB-RP105, 1x 40 mm cooling fan, 1x set of heat sinks, 1x set of screws, 4x foot-
pad stickers, 1x screw driver, 1x quick installation guide (Raspberry Pi
Protective case for Raspberry Pi
This Raspberry Pi case is a small form factor aluminium case designed for per-
formance and comfort. The case cools down the Raspberry Pi CPU and IC chip
thanks to its aluminum construction and included 40 mm fan. The case is acting
as a passive heat sink that improves the single board computer performances.
Key Features
• Protective enclosure designed specifically for the Raspberry Pi
• Quality aluminum casing with 40 mm cooling fan to dissipate heat
• Including two heatsinks and thermal pads to cool CPU and IC chipset
• All cut-outs for each interface are pre-cut into the sides of the enclosure
• Allows easy access to power, video, audio, USB, LAN, microSD card
• Prepared for wall mounting
Assembly
• Please follow the drawing to assemble the appropriated board to the IB-RP105.
• The heat sinks can be placed to the main chip sets on the board accordingly to
their sizes. Please remove the foil before stick them to the PCB.
• Alternatively, or in addition, you can use the 40 mm fan (included) at the top
cover of the case.
2
board not included
®
1 Model B+, Pi
®
2 and 3
®
2 Model B, Pi
® ®
not included)
®
2 and 3
®
3 Model