Novotechnik MAP 4000 Bedienungsanleitung Seite 63

Einstellung des Data-Logger – RTC
6.3.1b
INPUTS MEMORY
CHANNE. LIMITS
OUTPUT. DATA
SERVIC. AN. OUT.
DISP.
RTC
The lowest recording rate possible is once a day, the highest is every second. Under exceptional circumstances it is
possible to set the rate to 8 times per second by entering the recording period as 00:00:00. However, this mode is
not recommended due to the memory overload. Recordings are realised in a timeframe of one day and are repeated
periodically every following day. Recordings can take place either inside or outside of selected time intervals. The
duration of re-writing can be determined by the number of channels recorded as well as by the recording rate.
6.3.1c SETTING DATA LOGGING INTO INSTRUMENT MEMORY - FAST
INPUTS MEMORY
CHANNE. LIMITS
OUTPUT. DATA
SERVIC. AN. OUT.
DISP.
FAST
The memory operates on the basis of memory oscilloscope. Select an area of 0...100% of the memory capacity
(100% represents 8 192 individual recordings for a single channel measurement). This area is filled cyclically up
to the point when the recording starts (activated by the front panel button or by an external input). When the
remaining memory capacity fills up the recording stops. A new recording is possible after the deletion of the latest
recording. It is possible to abort a recording before its completion by reading out the data.
REWRIT.
START
STOP
PERIOD.
REWRIT. 3%
DEF
TRIGER
profi profi
Start der
START
Datenspeicherung
- Zeit Format HH.MM.SS
Ende der
STOP
Datenspeicherung
- Zeit Format HH.MM.SS
Einstellung des
PERIOD.
Zeitintervalles zur
Datenspeicherung
- determines the period in which values will
be logged in an interval delimited by the
time set under items START and STOP
- time format HH.MM.SS
- records are made on a daily basis in
selected interval and period
- item not displayed if "SAVE" is selected in
menu (INPUT > EXT. IN.)
Einstellung der
TRIGER
Datenspeicherung im
Gerät
- logging data into inst. memory is
governed by the folowing selection, which
determines how many percent of the
memory is reserved for data logging prior
to initiation of trigger imputse
- initialization is on ext. input or button
- setting in range 1...100 %
- when setting 100 %, datalogging works
in the mode ROLL > data keep getting
rewritten in cycles
1. Memory initialization
- clear memory (ext.input, button)
- LED "M" flashes, after reading TRIGGER
(%) memory is permanently shining. In
ROLL flashes constantly.
2. Triggering
- external input, button
- after the memory LED is full "M" turns off
- in the ROLL mode the trigger ends
datalogging and LED turns off
3 . Termination
- ext. input, button or reading data via RS
BEDIENUNGSANLEITUNG MAP 4000
MENÜ 6
|
63