Heat Application - SISER TS-ONE Gebrauchsanweisung

When the machine is turned on the display shows the actual temperature of the platen and the
LED is displaying L1<TEMPERATURE>
Setting the Time
Setting the Temperature
Press P1 <Set> again and the settings will be saved. The display returns to the initial screen
showing the current temperature.
Adjusting the Pressure

5.3 Heat Application

Place the fabric on the bottom platen, taking care to lay it evenly, avoiding any creasing. Follow
the manufacturers recommended heat application instructions.
Caution: keep the two platen separated when not in use.
Once the project is finished, turn the machine off, setting the switch to <0> (OFF).
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Press key P1 once, the display will show the application time
previously set. All the Leds will be illuminated: L2 <time> L3
<set>.
To increase or reduce the time press <+> and <->,the display
shows increase or reduction every time the keys are pressed.
To reduce the time quickly press and hold <->, then press <+>.
Lower the upper platen to activate a micro switch located
inside the press that controls the time countdown. The lapsing
time is displayed on the screen.
When the countdown is complete <0> a buzzer goes off. Once
the platen is raised the buzzer stops and the display shows the
temperature again.
Press key P1 again, the display will show the working
temperature set for the upper plate.
Leds L1 <Temperature> and L3 <Set> will be illuminated.
Use <+> and <-> as explained above to increase or reduce the
temperature.
To adjust the pressure raise or lower the bottom platen,
rotating it after loosening the lower dowel B (see fig. page
31). Remember to fasten the dowel again after making the
adjustment.
TS-One Manual for use and maintenance
Mod. PRD 20/3 - Last updating 02/2018
TS
ONE
5
EN
41