Mastervolt AC Power Analyser Betriebsanleitung Seite 5

2 SAFETY GUIDELINES AND MEASURES
2.1 WARNINGS AND SYMBOLS
Safety instructions and warnings are marked in this
manual by the following pictograms:
CAUTION
Special data, restrictions and rules with
regard to preventing damage.
WARNING
A WARNING refers to possible injury to the
user or significant material damage to the
charger if the user does not (carefully) follow
the procedures.
☞
A procedure, circumstance, etc which
deserves extra attention.
2.2 USE FOR INTENDED PURPOSE
1 The AC Power Analyser is constructed as per the
applicable safety-technical guidelines.
2 Use the AC Power Analyser only:
• in a technical correct condition;
• observing the instructions in the users manual.
WARNING
Never use the AC Power Analyser in
locations where there is danger of gas or dust
explosion or potentially flammable products!
3 Use of the AC Power Analyser other than mentioned
in point 2 is not considered to be consistent with the
intended purpose. Mastervolt is not liable for any
damage resulting from the above.
EN / AC Power Analyser / February 2011
2.3 ORGANIZATIONAL MEASURES
The user must always:
• have access to the user's manual;
• be familiar with the contents of this manual. This
applies in particular to this chapter, Safety Guidelines
and Measures.
2.4 MAINTENANCE AND REPAIR
1 If the electrical installation is switched off during
maintenance and/or repair activities, it should be
secured against unexpected and unintentional
switching on:
• take out all connectors;
• be sure that third parties cannot reverse the
measures taken.
2 If maintenance and repairs are required, only use
original spare parts.
2.5 GENERAL SAFETY AND INSTALLATION
PRECAUTIONS
• Connection and protection must be done in
accordance with local standards.
• Do not work on the AC Power Analyser or system if
it is still connected to a current source. Only allow
changes in your electrical system to be carried out
by qualified electricians.
• Check the wiring at least once a year. Defects such
as loose connections, burned cables etc. must be
corrected immediately.
SAFETY GUIDELINES AND MEASURES
5