Klarstein 10006681 Bedienungsanleitung Seite 13

Note:
a. For every first time use, it is normal thatˇs a slightly vibration sound may be occurred from electrical
pump inside the base unit for a few seconds when steam ironing started. It is because there is air inside the
filter, it will stop till the air inside the filter has been pumped out. If this abnormal conditions coutinuously
happen for more than 60 seconds, please check whether water tank and filter assembled correctly or not.
b. When temperature control dial is set at ¨synthetic〃 position, it only suits for dry ironing, max steam will
be obtained when set at ¨MAX〃 position, when set at ¨Wool Silk〃 steam will be smaller gradually.
Dry Ironing:
1. Connect the appliance to a suitable socket outlet.
2. Set temperature control dial to desired position according to ironing instructions on the garment
label or fabric setting chart. Heating indicator light (red) at iron unit lights up to indicate the unit
being heated up. When the heating indicator light turn off, the desired temperature has been
reached. During use, heating indicator light will cycle from ON to OFF and then OFF to ON. It
indicates that the unit is heat preservation.
3. After using, take the iron unit back onto base unit, turn temperature control dial to ¨MIN〃, and
then unplug from main socket.
Note: When changing your Temp setting from higher setting to lower, it is proposed that not to start ironing
immediately since it may cause burns to your fabrics. Please wait till temperature indicator light lights up
steadily, and then start ironing.
Vertical steam ironing:
Follow the steam ironing process, and then hold the iron in vertical position between 5cm and 15cm away
from the hanged fabrics. Press down steam switch, this will create vertical steam. This feature is especially
used for removing creases from hanging clothes and curtains. Never directly perform steam ironing on
people. (Fig.8)
Handle attached to the base unit used to carry the appliance. Before use, please put the handle down as
following method: Press down two handle buttons synchronously, and then lay the handle down. (Fig.9)
After use, allow the appliance completely cool down, then wind power cord around the cord storage of base
unit and put the iron onto base unit. Lift handle up until a ¨pa〃 sound is provided, it indicates that the
handle has been locked in place and you can carry the appliance by the handle.
Handle