Klarstein 10006681 Bedienungsanleitung Seite 11

5. If the fabric consists of various kinds of fibres, always select the temperature required by the most
delicate fibres, i.e. the lowest temperature. If, for example, an article consists of 60%polyester and
40%cotton, according to the fabric setting chart it should be ironed for polyester and without steam.
6. If you do not know what kind of fabric the article is made of, iron a piece of the material which is
not visible when you wear to find out the appropriate temperature for your articles.
7. Pure woolen fabrics (100% wool) should be ironed with the iron setting to steam ironing position. It
is advisable to set the temperature control dial to ¨Max〃 position and use a dry pressing cloth.
8. When steam ironing woolen fabrics, shiny patches may occur. You may prevent this by turning the
article inside out and ironing the reverse side.
9. After using of steam ironing for cotton fabrics, do not iron articles required by lower temperature
(such as nylon etc.) immediately. It is advisable to adjust the temperature dial to the lower setting,
waiting till the power indicator light turn off, and then you can start ironing.
IMPORTANT HINTS: Do not fill water tank with vinegar, perfume, starch, chemically descaled water or
descaling agents.
Prepare the appliance for use
1. Check if the rating indicated in the rating plate corresponding to the main voltage in your home.
2. Press handle button to lay handle down.
3. Remove the protective foil or sticker or card from the soleplate.(Fig. 1)
4. Fully unwind and straighten the power cord and the supply hose.
5. Place the appliance on a stable, level and horizontal surface such as ironing board
6. Place the iron onto the iron rest plate horizontally at the base unit.
Fill water tank:
1. Press the water tank lock upwards and slide the detachable water tank outwards from the
base.(Fig.2)
2. Take the filter upwards out from the water fill hole. (You can take the filter out of the opening for
filling water into water tank, or fill water into water tank directly with the filter existing in the
opening).(Fig.3)
3. Fill the water tank up to or below the ¨MAX〃 fill line with clean tap water. (Fig.4)
4. Replace filter back into water tank. When move, please hold the water tank by two hands. (Fig.5)
5. Replace the water tank into the base unit again. It will be locked in place with the base unit until a ¨
click〃 sound is provided. (Fig.6)
6. Always pour out the remaining water after use. (Fig.7)
How to use your Station