Klarstein 10006681 Bedienungsanleitung Seite 12

Note:
When the water level reaches a low level or empty, pump will provide sound to indicate refilling. It must
stop to use the appliance immediately and refill water tank as the methods mentioned above.
Steam function setting:
After power on, set temperature control dial to steam ironing position. Heating the indicator light on an iron
unit lights up to indicate the unit being heated up. When desired temperature has been reached, heating
indicator light turns off, it is ready for using. During use, heating indicator light will cycle from ON to OFF
and then OFF to ON, it indicates that the iron is automatically heat preservation. Press steam button to start
steam ironing. When you adjust the temperature control dial, steam rate will be adjusted accordingly. MAX
steam will be obtained when set at MAX position, it will be smaller gradually when turn to 〃WOOL/SILK〃
position.
Note: When temperature control dial is located at SYNTHETIC 〃, it is proposed not to activate steam
ironing since temperature is too low to produce steam, it only suits for dry ironing,
Steam Ironing
1. Fill water tank with clean tap water refer to above filling instruction. For better performance, please
immerse filter in water for several minutes before installing it into the water tank).
2. Connect the unit into a suitable main socket. Turn temperature control dial to steam ironing position,
heating indicator light on iron unit lights up to indicate that the unit is being heated up. When it turn
off, the desired temperature has been reached,it is ready for steam ironing.During use,heating
indicator light will cycle from ON to OFF and then OFF to ON, it indicates that the iron is
automatically heat preservation.
3. Before first time use of steam ironing, please clean the iron as below methods: Take the iron unit up
from the base unit, press steam button underneath the handle to allow steam release for 30
seconds and then stop for 30 seconds, do so as a cycle, and repeat above cycle again. The iron is
not ready for using until the heating indicator light turns OFF.
4. During steam ironing, steam rate will be varied when temperature control dial is adjusted to
different positions. This can prevent water leakage caused from soleplate.
5. After using, take the iron unit back onto base unit,turn temperature control dail to ¨MIN〃, and then
unplug from main socket.
6. Slide water tank out from the base unit and empty it.