Straightened Hair; Curly And Wavy Hair; Hair With Volume And Bounce - Beurer HT 80 Gebrauchsanweisung

Step 2: Plugging the mains plug into the socket
Insert the mains plug of the hot air brush into a suitable socket.
>
Step 3: Preparing your hair
Dry your hair with a towel beforehand.
>
Comb your hair thoroughly.
>
Only use the hot air brush on pre-dried, slightly damp and well-brushed hair.
Step 4: Blower and temperature settings
Slide the sliding switch [6] on the hot air brush to the required blower and temperature setting (2, 1 or
Setting Blower and temperature settings
2 High blower setting, high temperature
1 Gentle blower setting, medium tempe-
rature
High, cold blower setting
Step 5: After use:
After use, slide the sliding switch [6] to position 0.
>
Place the hot air brush on a heat-resistant surface and allow to cool.
>
Then clean the hot air brush as described in chapter "7. Cleaning".
>
Store the hot air brush in a safe, cool and dry place. If you prefer, you can hang up the hot air brush using
>
the hanging eyelet [10].

6.2 Straightened hair

Use the heated brush [3].
>
If you have fi ne hair, slide the sliding switch [6] to position 1.
>
If you have thick hair, slide the sliding switch [6] to position 2.
>
Take sections of hair by the root and glide the heated brush from there down to
>
the tip.
Repeat until your hair is straight.
>

6.3 Curly and wavy hair

Use the curling brush [2].
>
If you have fi ne hair, slide the sliding switch [6] to position 1.
>
If you have thick hair, slide the sliding switch [6] to position 2.
>
Using the rotation buttons, wind a section of hair from the tips towards the roots.
>
Hold this position for approximately 20 seconds.
>
After the 20 seconds, slide the sliding switch [6] to the
>
section.
Use the rotation buttons to unwind the section completely.
>
Repeat steps 1 to 6 to curl the rest of your hair.
>

6.4 Hair with volume and bounce

Round brushing outwards:
If you have fi ne hair, slide the sliding switch [6] to position 1.
>
If you have thick hair, slide the sliding switch [6] to position 2.
>
Place the heated brush [3] over a section of hair at the tips.
>
Hold down the wind rotation button until the tips curl out as required.
>
Hold this position for approximately 20 seconds.
>
Hair type/application
For thick hair
For fi ne hair
For fi nishing the hairstyle
position to fi nish the
14
).