Salda FLEX RIS 1500 PW 3.0 Bedienungsanleitung Seite 26

EN
6.4.3. "Dx coolOFF" – chlorofl uorocarbon cooling is switched
off at "Cool PI", %
6.4.4. "OutDoot T.C" – when ambient air temperature ex-
ceeds this setting, cooling is allowed, 10–30 °C
6.5. "Add.Func."
6.5.1. "Night Cool" – night cooling "On/Off"
6.5.2. "CO2" – highest allowed level of CO2. If exceeded, the
supply air fl ow is increased, %, ppm
6.5.3. "Fast Butt." – select the function of the fast button:
"Run/Standby" or "Boost" (see 6.6)
6.5.4. "FanStopTime" – time for cooling of the electrical
heater after switching the unit off, 0–250 sec.
6.6. "Boost Ctrl."
6.6.1. "Boost timer" – operation period of the function
"Boost", min.
6.6.2. "Boost SAF" – supply air fan speed during operation of
the function "Boost", %, Pa
6.6.3. "Boost EAF" – extracted air fan speed during operation
of the function "Boost", %, Pa
6.7. "SAF Ctrl." – supply fan speed (pressure) setting
6.7.1. "SAF Low" – set supply fan speed at the selected
speed "Low", %, Pa
6.7.2. "SAF Normal" – set supply fan speed at the selected
speed "Medium", %, Pa
6.7.3. "SAF High" – set supply fan speed at the selected
speed "High", %, Pa
6.8. "EAF Ctrl." – extraction fan speed (pressure) setting
6.8.1. "EAF Low" – set extraction fan speed at the selected
speed "Low", %, Pa
6.8.2. . "EAF Normal" – set extraction fan speed at the
selected speed "Medium", %, Pa
6.8.3. "EAF High" – set extraction fan speed at the selected
speed "High", %, Pa
6.9. "Version" – version of the unit software, board, settings are
shown; when "OK" is pressed, panel version and software date
is shown. Return to menu by pressing "
6.10. "Service" – additional options of the unit's settings (see
"Tuner's manual").
6.11. "Filters"
6.11.1. "SetTimer" – the operation time for the unit is set until
contamination of the fi lters will be reported
6.11.2. . "ReSetTimer" – resetting the contamination timer for
the fi lters; is used after changing the fi lters and to reset
the message "Change the fi lters" in the information line
6.11.3. "Curr.Timer" – indication of the unit operation time
left to the moment when fi lter contamination well be
reported, h
www.salda.lt
".
21