Salda FLEX RIS 1500 PW 3.0 Bedienungsanleitung Seite 21

EN
2.
"Fa "Fan speeed" – allows
"Stop" – the unit is stopped
"Low", "Medium", "High"
The speed of the supply and extraction motors of the units with EC
motors can be adjusted individually (see II.6.7 and II.6.8)
3.
"Set "Se temperature"
The desired supply or extracted air temperature can be set from 15
to 30 °C.
4.
"Me "Menu" – other settings
"Operation schedule"
"Date/Time"
"Alarm preview"
"Languages"
"Sensor preview"
"Additional"
5.
Indica Indica Ind ication ication tion based based based on t on on
extrac ext extrac racted racted ted air air air temperature: temperature: temperatur
or "Ex "Extracted air temperatu
6.
Meaning Mea of the additiona
If several error messages exists, they are interchanged (the fi rst mes-
sage is shown and then the next message is shown, etc.)
"NC" or "No connection" – no connection with the unit's control
board.
"Unfreezing" – activated unfreezing function for the plate heat
exchanger.
"Change fi lters" – clogged fi lters (signal from the pressure relay).
"DR fault" – fault of the moisture sensor
"Economic" – reduction of the speed without reaching the set tem-
perature.
"Stop input" – the unit is stopped from the external Stop input signal.
"Standby mode" –when the fast button "Run/Standby" function is
selected (see II.6.5.3)
"Boost" – when the fast button "Boost" function is selected (see
II.6.5.3) or the external "Boot" signal.
"Night cooling" – if the selected function is on (see II.6.5.1)
"High CO2 level" – allowed CO2 level is exceeded (see II.6.5.2)
"Battery low" – Battery of the FLEX panel should be replaced with
the new one.
7.
Cur Current time and date
www.salda.lt
selecting t se g the he speed ed
gs (see II.)
the the he he setting o setting setting of t of t f f the the he maintaine maintaine mai mai nta
e: e: (see I (see I (see II.6.3. .3.1) "Suppl pply
ature"
onal informa rmation line ine
is is displayed ( d (see II.2) .2)
Manual
Fan speed
Set temperature
Supply air temp.
Deicing
Fan speed
Set temperature
Menu
Supply air temp.
Deicing
Fan speed
Set temperature
Menu
Supply air temp.
Deicing
ined ined d s supp supp upply upply ly or or or or
air ir temper peratu ature"
Fan speed
Set temperature
Menu
Supply air temp.
No connection
System NC
Date – Time
View Alarms
Languages
View sensors
Extra
middle
low
Stop
7:28 2013-06-04
low
20 °C
19 °C
18 °C
7:28 2013-06-04
low
19 °C
7:28 2013-06-04
19 °C
18.7 °C
7:28 2013-06-04
Sun.
Sun.
Sun.
low
Sun.
6/7
17