Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Carrying out calibration in short form with the KIOX 300 display:
1.
Switch on the e-bike → [Kiox shows slowly increasing speed, calibration level 1]
2.
Switch off e-bike at approx. 10.0
3.
Switch on the e-bike → [Kiox shows slowly increasing speed and keeps
dropping towards 0
4.
Switch off e-bike at exactly 10.0
Start the calibration again manually with the Kiox 300:
1.
Switch on e-bike → [Kiox stays at 0.0
2.
Switch off the e-bike after it has booted up completely, wait 5 seconds
3.
Switch on e-bike → [Kiox shows 10.0
tuningmode]
4.
Switch off the e-bike after 10.0
5.
Switch on the e-bike → [CalibraSon level 1]
Carrying out the calibration for e-bikes without a display:
1.
Switch on the e-bike and make sure that the magnet is not level with the sensor
2.
Position the magnet at the level of the sensor for 5 seconds
3.
Generate 4 impulses by pushing the bike back and forth and then wait at least 5 seconds
4.
Ride off and stop as exactly as possible at the point where the motor support ends (approx. 25-26 km/h)
and then switch off the e-bike
5.
Switch the e-bike on again and drive to the desired speed at which the motor support should end and
stop again. Then switch off the e-bike
, wait 5 seconds
, calibration level 2]
, wait 5 seconds
, 1:1 mode]
with correct calibration (otherwise a different constant value),
or another constant value is displayed, wait 5 seconds
Werbung
