Herunterladen Diese Seite drucken

Simplek Pro Nano Bedienungsanleitung Seite 18

Version bosch gen1 - gen4
Vorschau ausblenden Andere Handbücher für Pro Nano:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3. Operation
3.1. 1:1-Mode
1:1 mode is always started after the e-bike has been operated in tuning mode or 1:1 mode for more than 15 seconds
and switched off. In this mode, the e-bike behaves as if it were not modified.
3.2. Tuningmode
Activating the tuning mode with the Kiox 300 display:
1.
Switch on e-bike → [Kiox stays at 0.0
2.
Switch off the e-bike after it has started up completely, wait at least 5 seconds.
3.
Switch on e-bike → [Kiox shows 10.0
tuningmode]
Alternative activation of the tuning mode for e-bikes without a display:
1.
Switch on the e-bike and make sure that the magnet is not on the sensor
2.
Position the magnet at the level of the sensor for 5 seconds
3.
Generate 2 impulses by pushing the bike back and forth and then wait at least 5 seconds
Speed representation: The speed actually driven remains readable. Up to 22
it is displayed via the second digit and the decimal place. If the speed limit is reduced, values must be subtracted
(see setting the limiting speed). Speed display example: 23.5
Automatic route compensation: In order to compensate for the difference between the distance actually
covered and the distance displayed, the maximum speed driven is displayed after about one minute of standstill
until the distance has been covered. As soon as the difference has been compensated, the display drops to 0.0
and the e-bike switches itself off after a while. If the e-bike is switched off beforehand, the sIMPLEk saves the
difference and catches up later. As a result, the maximum speed and the distance traveled/total distance are
correctly displayed.
Note Stealth Mode: For the Stealth mode to work correctly, it is necessary for the control panel to allow the
wheel circumference to be changed. After activating the stealth mode, the wheel circumference must be
permanently set to the smallest possible value, otherwise the displayed speeds will not be correct.
, 1:1 mode]
with correct calibration (otherwise a different constant value),
→ 35
it is displayed 1 to 1, above 22

Werbung

loading

Verwandte Produkte für Simplek Pro Nano