Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.4. Installation example Bosch Performance- and Cargo-Line CX from 2022
and newer:
Tools needed:
•
4 mm Allen key (Fully cased version Torx 20 socket
wrench)
•
Optional: flat nose pliers
•
ISIS crank puller (only for the full fairing version)
In the case of the fully clad version, the crank must also be removed. To do this, loosen the 8 mm allen screw (image
3) and remove the crank using the crank puller. Loosen the screws of the engine cover (image 11 or image 13). Now
the engine cover can be removed. If necessary, pull the plug of the speed sensor (image 12 or image 14) using flat-
nosed pliers.
Now connect the plug of the simplek to the position of the previously unplugged speed sensor. The speed sensor is
then connected to the connector of the simplek. When plugging in, make sure you hear/feel it clicks into place.
Fully clad version
Partially clad version
image 11
image 13
image 12
image 14
Werbung
